E-Flite (EFL)
POWER 10 (Part # EFLM4010A)
The Power 10 is designed to deliver clean and quiet power for 10-size sport and scale airplanes.
Tech Notes |
* Maximum Operating Temperature: 220 degrees Fahrenheit
* Adequate cooling is required for all motor operation at maximum current levels.
* Maximum Burst Current duration is 15 seconds. Adequate time between maximum burst intervals is required for proper cooling and to avoid overheating the motor.
* Maximum Burst Current rating is for 3D and limited motor run flights. Lack of proper throttle management may result in damage to the motor since excessive use of burst current may overheat the motor.
Examples of Airplane Setups:
Please see our web site for the most up-to-date information and airplane setup examples.
NOTE: All data measured at full throttle. Actual performance may vary depending on battery and flight conditions.
E-flite Brio 10
Motor: Power 10
ESC: E-flite 40A Brushless V2 (EFLA311B)
Prop: APC 12x6E (APC12060E)
Battery: Thunder Power PRO LITE 2100mAh 11.1V 3-Cell (THP21003SPL)
Flying Weight w/Battery: 2.1 lbs
Amps Volts Watts Input Watts/Pound RPM
37.2 9.6 357 170 7800
Expect good speed and extreme vertical power for artistic aerobatics. Average duration is approximately 6-9 minutes depending on throttle management.
E-flite Ultimate 20-300 10e
Motor: Power 10
ESC: E-flite 40A Lite Pro SB Brushless (EFLA1040L)
Prop: APC 12x6E (APC12060E)
Battery: Thunder Power 2600mAh 11.1V 3S PRO LITE V2 Li-Po (THP26003SPL2)
Flying Weight w/Battery: 40.7 oz (2.5)
Amps Volts Watts Input Watts/Pound RPM
40.2 10.7 430 172 8350
Expect ballistic power very strong vertical performance ideal for pulling out of hovers. Average duration is approximately 5-8 minutes depending on throttle management.
You will need...
40A ESC
6- to 10-cell Ni-MH/Ni-Cd or 2–3S Li-Po
Specifications |
Type: Brushless outrunner motor
Size: 10-size
Bearings or Bushings: One 5 x 14 x 5mm Bearing, and One 5 x 11 x 5mm Bearing
Wire Gauge: 16
Recommended Prop Range: 10x5–12x6
Voltage: 7.2–12
RPM/Volt (Kv): 1100
Resistance (Ri): .043 ohms
Idle Current (Io): 2.10A @10V
Continuous Current: 32A
Maximum Burst Current: 42A (15 sec)
Cells: 6–10 Ni-MH/Ni-Cd or 2–3S Li-Po
Speed Control: 35–40A brushless
Weight: 122 g (4.3 oz)
Overall Diameter: 35mm (1.40 in)
Shaft Diameter: 5mm (.20 in)
Overall Length: 43mm (1.60 in)